Preparation
Attaching the stand unit
• Before attaching (or detaching) the stand, unplug the AC cord. | 3 Insert the stand into the openings on the bottom | 5 Attaching the stand cover. | |
• Before performing work, spread cushioning over the | of the TV (hold the stand so it will not drop from | 1Insert the stand cover. | |
surface on which you will be laying the TV. This will | the edge of the base area). | 2Insert and tighten the M4 screw (length: | |
prevent it from being damaged. | • Make sure that the stand is firmly inserted into the | 8 mm) into the holes of the stand cover. | |
• Be sure that two or more persons attach the stand. | |||
TV. Improper installation may result in tilting of the | • Tighten the screw by pressing the bottom of the | ||
CAUTION | |||
TV set. | stand base to the TV side. | ||
• Attach the stand in the correct direction. | Soft cushion | M4 screw | |
• Be sure to follow the instructions. Incorrect installation | |||
|
|
of the stand may result in the TV falling over.
• After attaching the stand to the TV, do not hold the stand when you put up, set up, move or lay down the TV.
• Do not remove the stand from the TV unless using a wall mount bracket to mount it.
1 Confirm that there are 14 screws (twelve M5 screws and two M4 screws) supplied with the stand unit.
2Attach the supporting post to the stand base.
1Insert the claws of the supporting post into the stand base.
2Secure the post and the base using the M5 screws (length: 14 mm) and a screwdriver.
M5 screws
4 Insert and tighten the M5 screws (length: 14 mm) into the holes on the rear of the TV.
M5 screws
NOTE
• To detach the stand unit, perform the steps in reverse order.
• A screwdriver is not supplied with this product.
• In the installation procedure, be careful not to catch your fingers between the TV set and the floor.
5
