Preparation
Attaching the stand unit
•Before attaching (or detaching) the stand, unplug the AC cord.
•Before performing work, spread cushioning over the surface on which you will be laying the TV. This will prevent it from being damaged.
CAUTION
•Attach the stand in the correct direction.
•Be sure to follow the instructions. Incorrect installation of the stand may result in the TV falling over.
•After attaching the stand to the TV, do not hold the stand when you put up, set up, move or lay down the TV.
•Do not remove the stand from the TV unless using a wall mount bracket to mount it.
1Confirm that there are twelve screws (eight long screws and four short screws) supplied with the stand unit.
21 Set the supporting post for the stand unit onto the polystyrene foam.
2Attach the stand base to the supporting post.
3Insert and tighten the eight screws into the eight holes on the bottom of the stand base.
•Hold the stand unit securely with one hand, and then tighten the screws.
Stand base |
|
|
|
|
|
|
|
|
| Long screws | |||||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
3Insert the stand into the openings on the bottom of the TV (hold the stand so it will not drop from the edge of the base area).
•Make sure that the stand is firmly inserted into the TV. Improper installation may result in tilting of the TV set.
•Instead of using a soft cushion, the cardboard box that the TV is packed in can be assembled and used as a work table (refer to the instructions on the box to assemble the work table).
Soft cushion
4Insert and tighten the four screws into the four holes on the rear of the TV.
Short screws 
NOTE
•To detach the stand unit, perform the steps in reverse order.
•A screwdriver is not supplied with this product.
•In the installation procedure, be careful not to catch your fingers between the TV set and the floor.
TV front
Supporting post | 5 |
|
