Basic adjustment settings

Power Control

Power control setting allows you to save energy.

Power control for AV sourceNo signal off
Power control for PC source

Power control setting allows you to save energy.

Power management

When set, the power will automatically shut down.

When set to “Enable”, the power will automatically shut down if no signal inputs for 15 minutes.

1 Press MENU and the MENU screen displays.

1

Repeat steps 1 and 2 in No signal off.

2

Press a/bto select “Power Management”,

 

and then press ENTER.

2 Press c/dto select “Power Control”.

3

Press a/bto select “Mode1” or “Mode2”,

 

and then press ENTER.

3 Press a/b to select “No Signal Off”, and then press ENTER.

4 Press c/d to select “Enable”, and then press ENTER.

 

 

 

 

 

 

 

Enable

 

 

Disable

 

 

 

 

 

 

 

•Five minutes before the power shuts down, remaining time displays every minute.

NOTE

•“Disable” is factory preset value.

•When a TV program finishes, this function may not operate.

No operation off

When set to “Enable”, the power will automatically shut down if there is no operation for 3 hours.

Off

Mode1

Mode2

Selected item

 

Description

 

 

Off

• No power management

•

Factory preset value.

 

 

 

 

 

•

If no signal inputs for 8 minutes, the power

 

 

shuts down.

 

• Even if you start using the PC and the signal

Mode1

 

inputs again, the TV stays off.

• The TV turns on again by pressing TV

 

 

POWER on the remote control unit. (See

 

 

page 17).

 

•

Pressing POWER on the TV will have the

 

 

same result.

 

 

 

• If no signal inputs for 8 seconds, the TV

Mode2

 

enters standby mode.

•

When you start using the PC and the signal

 

 

 

inputs again, the TV turns on.

 

 

 

1

Repeat steps 1 and 2 in No signal off.

2

Press a/bto select “No Operation Off”, and

 

then press ENTER.

3

Press c/d to select “Enable”, and then

press ENTER.

• Five minutes before the power shuts down, remaining time displays every minute.

NOTE

• “Disable” is factory preset value.

NOTE

•When using a digital PC and setting “Mode2” in Power management, the power may not turn back on automatically even if the signal inputs again.

•If you turn off the power by disconnecting AC cord when setting “Mode2” in power management, the TV may not function properly after turning the power on again. In such case, press TV POWER on the remote control unit.

•Pressing POWER on the TV will have the same result.

44