QUICK REFERENCE

TV GUIDE ON SCREEN™ QUICK SETUP SHEET

Once you set up the TV according to this operation manual, you are ready to set up TV Guide On Screen!

Note: TV Guide On Screen™ interactive program guide supports cable-ready, cable box and digital cable services as well as over-the-air broadcast. It does not provide listings for satellite services.

After completing the TV’s initial set up, you see the TV

2

Find the VCR and Cable Box IR Sensors.

Guide On Screen Set up Welcome Screen.

 

To control recording, find the VCR’s IR sensor.

Note: If TV Guide On Screen is not set up, pressing TV

 

 

1Turn the VCR off.

 

GUIDE while watching TV will display the Welcome

 

 

 

2Hold the VCR remote so that it touches the

Screen.

 

 

front of the VCR (Figure 1).

 

 

 

 

 

 

3Move the remote across the front while

 

 

pressing POWER (Figure 2). (You must press

 

 

and release the power button each time you

 

 

move the remote; holding down the button will

 

 

not work).

 

 

 

4When the VCR powers on, you have found

 

 

the sensor.

 

 

 

5Remember the location of the sensor, and go

Follow the on-screen instructions

 

to step 3.

 

 

If you have a cable box, repeat this procedure

If you previously skipped TV Guide On Screen setup,

 

using the cable box and its remote, and then

 

go to step 3.

 

you see the Reminder Screen.

 

 

 

Figure 1

Figure 2

 

 

3

Note: If you press ENTER and the screen does not change, make sure that the batteries in the remote control are properly installed.

If you need to control a cable box and/or a VCR, complete steps 1 through 3. If not, go to step 4.

1

Find and Connect the included G-LINK cable

 

into the G-LINK terminal.

 

G-LINK cable with

 

Double-Sided Tape

G-LINK cable

4

Correct Incorrect

Place the G-LINK cable(s)

To control a VCR, place one of the G-LINK wands underneath the VCR approximately 1 inch in front of the sensor you found in step 2. If you have a cable box, place the other G- LINK wand approximately 1 inch in front of the sensor you found in step 2.

Use the double-sided tape to secure each G-LINK cable.

 

This end is connected to the TV as

 

shown in step 1.

G-LINK

VCR

or

cable

Cable Box

1 inch

G-LINK wand

 

Use the TV remote for On-Screen Setup

1Press a/b/c/dand ENTER to highlight an item in a Setup screen.

2Press ENTER to select that item.

a/b/c/d

ENTER

8