Sharp LL-171A LL-171G operation manual Connecting the monitor and turning the monitor on and off

Connecting the monitor and turning the monitor on and off

Analog connection [LL-171G]

Connect the accessory analog signal cable, or separately-sold analog signal cable (model name: NL-C02E) to the analog RGB output terminal of the computer.

-Connect the accessory analog signal cable to the analog RGB input terminal (INPUT-1).

-Connect the separately-sold analog signal cable (model name: NL-C02E) to the DVI-I input terminal (INPUT-2).

DVI-I input terminal (INPUT-2)

Analog RGB input terminal (INPUT-1)

Analog signal cable	Analog RGB output
	terminal

-Paying attention to connector direction, firmly insert the signal cable vertically into the connector, and then tighten the screws at both sides.

If connecting to a D-sub15 pin 2 row Apple Power Macintosh, attach a Macintosh conversion adapter (commercially available) to the analog signal cable.

Macintosh conversion adapter

Note:

-If connecting to the Sun Ultra series, a conversion adapter (commercially available) may be required.

Digital connection [LL-171G]

Connect the accessory digital signal cable to the digital RGB output terminal of the computer.

-The monitor has an input for connecting to a computer with a DVI-compatible output connector (DVI-D24 pin or DVI-I29 pin) and SXGA output capability. (Depending on the type of computer to be connected, the display may not work correctly.)

DVI-I input terminal (INPUT-2)

Digital signal cable Digital RGB output terminal

-Paying attention to connector direction, firmly insert the signal cable vertically into the connector, and then tighten the screws at both sides.

Set the monitor as follows when establishing a digital connection with a Power Mac using an ADC- DVI adapter made by Belkin. (Operation has been checked with the Power Mac G4 M7627J/A.)

-Perform settings with the Power Mac power supply off.

1.After connecting the power cord, turn on the monitor's main power.

2.Press the button and button simultaneously, and while doing this press the power button (i.e. turn the power on).

MAC DIGITAL

INPUT-2 OFF ON

O K [MENU]

3.Set to [ON] with the buttons.

-Do not set to [ON] if you are not using a Belkin ADC-DVI adapter, as this may result in incorrect display.

4.Press the MENU button. This completes setting.

English

13