Instructions for attaching a VESA compliant arm
English
An arm based on the VESA standard can be at- tached to the monitor. The arm must be purchased separately.
When choosing the arm to be installed please take note of the following points.
-The arm should be compatible with the VESA standard, and there must be a gap of 75mm x 75mm between the screw holes on the section to be attached.
-The arm must not fall off or break off after being attached to the monitor.
5. Attach the arm to the monitor with four screws.
1.Ensure that both the monitor and computer are switched off.
2.Remove the AC adapter and the RGB signal cable.
3.Press down on the stand and gently fold back the monitor.
Information
The screws used to attach the arm should be M4 screws with a length of 4 mm ~ 6 mm protrud- ing from the surface to be attached. Using any other kind of screw may lead to the monitor falling off or damage to the internal part of the monitor.
4 ~ 6 mm
Screw used to attach arm
Arm
Part of monitor to which arm is attached
6.Connect the AC adapter and the RGB signal cable.
4.Being careful not to damage the monitor, spread out a soft cloth and lay the monitor on it display- side down.
25
