Adjusting the screen display (When using an analog signal)
Manual screen adjustment | ADJUSTMENT Menu |
|
Adjustments can be made using OSD (On Screen Display) Menu provided.
On Screen Display for adjustment
If you are using Windows, open the Adjustment Pattern on the accompanying Utility Disk. (p.16)
If your system is not Windows, you can not use the Adjustment Pattern. Therefore display an image that makes the entire screen light and adjust it through checking visually its actual tone.
This chapter provides the procedure how to adjust the screen by using Adjustment Pattern (for Windows).
How to adjust
1.Press the MENU button.
The ADJUSTMENT Menu will be displayed. (Example: Displayed screen of the
At this point relevant menu options can be adjusted.
Each time the MENU button is pressed the next menu is selected. (ADJUSTMENT → GAIN CONTROL → WHITE BALANCE→ MODE SELECT → OSD Menu disappears)
Notes:
-The OSD Menu automatically disappears approximately 30 seconds after the last command.
-The OSD Menu screen shown as an example is from the
MANUAL: Individual menu options are manually adjusted.
AUTO: Every menu option is automatically adjusted.
Notes:
-Press the 
button to select [AUTO].
-To choose a menu option: 
/ MODE button
-To go to the next menu: MENU button
CLOCK
The figure below demonstrates how to adjust so that vertical flicker noise is not emitted.
( | buttons) |
Vertical flicker noise
PHASE
The figure below demonstrates how to adjust so that horizontal flicker noise is not emitted.
(
buttons)
Note:
-Adjustments to [PHASE] should be made only after [CLOCK] has been correctly set.
Horizontal flicker noise
H-POS (horizontal positioning) and V-POS (vertical positioning)
To center the Adjustment Pattern within the boundaries of the screen, adjust the
(
buttons)
Screen frame
Adjustment
Pattern
English Español Italiano Français Deutsch English
17
