Controlling the Monitor with a PC (Continued)
| Daisy chain connection from a single PC...... | Advanced operation |
Connect with RS-232C straight cable between the PC’s COM port (RS-232C connector) and the RS-232C input terminal on the rear of the first monitor.
Next, connect RS-232C straight cable to the first monitor’s RS-232C output terminal and to the second monitor’s RS-232C input terminal. Connect in the same way to the third and subsequent monitors. The number of connectable monitors varies depending on the length of the cable used and the surrounding environment.
▼ First monitor | ▼ Second monitor |
RS-232C | | | | RS-232C | RS-232C | | | | RS-232C |
output terminal | | | input terminal | output terminal | | | input terminal |
| | | | | | | | | |
| | | | | | | | | |
▼ PC
To COM port
RS-232C straight cable(commercially available)
Communication conditions
Set the RS-232C communication settings on the PC to match the monitor’s communication settings as follows:
Baud rate | 9,600 bps |
Data length | 8 bits |
Parity bit | None |
Stop bit | 1 bit |
Flow control | None |
