Sharp PN-465E Binding Cables, Preparing the Remote Control Unit, 13 E, Setting the batteries

Binding Cables

Cable clamp positions

Cable clamp attachment

Insert the cable clamp into a hole. (any hole available)

Cable clamp

Attaching the cable clamp

The cables connected to the terminals on the back of the monitor can be neatly bundled using the supplied cable clamps as shown in the illustration.

Caution

•Verify the position for attaching a cable clamp in advance. A cable clamp cannot be removed once it is attached.

Fastening the power cord

The power cord can be fastened using the supplied power cord clamp. This will prevent the power cord from being disconnected accidentally.

1.Attach the supplied power cord clamp to the power cord, making sure the power cord clamp is circular hole- sidedown.

2.Insert the tip of the band into the hole for the power cord clamp.

3.While holding the tail of the band, slide the fastened part toward the AC input terminal.

ENGLISH

1	2	3
		Hole for
	Band	the power
		cord clamp
Fastened	Power cord
part	clamp

Preparing the Remote Control Unit

Setting the batteries

1.Press the cover gently and slide it in the direction of the arrow.

2.See the instructions in the compartment and put in the supplied batteries (2 R-6 batteries) with their plus (+) and minus (-) sides oriented correctly.

3.Close the cover.

TIPS

•The supplied batteries (2 R-6 batteries) may become exhausted faster depending on the storage condition. It is recommended that you replace them with new batteries (commercially available) earlier than specified.

•If you will not use the remote control for a long time, remove the batteries.

•Use manganese or alkaline batteries only.

Remote control operation range

The operation range of the remote control unit is approx. 5 m at an angle of approx 10° from the centre to the top/bottom/ right/left of the remote control sensor.

Remote control sensor

	5 m
10°	5 m
	10°

TIPS

•Do not expose the remote control unit to shock by dropping or stepping on it. This could lead to a malfunction.

•Do not expose the remote control unit to liquids, and do not place it in an area with high humidity.

•The remote control unit may not work properly if the remote control sensor is under direct sunlight or strong lighting.

•Objects between the remote control unit and the remote control sensor may prevent proper operation.

•Replace the batteries when they run low as this may shorten the remote control’s operation range.

•If a fluorescent light is illuminated near the remote control unit, it may interfere with proper operation.

•Do not use it with the remote control of other equipment such as air conditioner, stereo components, etc.

13 E