Connecting Peripheral Equipment
Caution
Connection with AV equipment
•Be sure to turn off the main power switch and disconnect the plug from the power outlet before connecting/ disconnecting cables. Also, read the manual of the equipment to be connected.
•Be careful not to mix up the input terminal with the output terminal when connecting cables. Mixing up the input and output terminals may cause malfunctions and the other problems.
Connection with a PC
AV1 input terminal
AV2 input terminals
Cr/Pr Y Cb/Pb
AV audio input terminals
PC1 input terminal
PC2 input terminal
PC3 input terminals
VH
R G B
PC audio input terminal
AV3 input terminal
• Use a commercially available signal cable |
for the AV1 input terminal. Set DVI SELECT on the OPTION |
menu to AV (DIGITAL) when using the AV1 input terminal. |
(See page 19.) |
• Use a commercially available component cable (BNC) for |
the AV2 input terminals. Set BNC SELECT on the OPTION |
menu to AV (COMPONENT) when using the AV2 input |
terminals. (See page 19.) |
• Use a commercially available video cable (BNC) for the |
AV3 input terminal. |
• Use a commercially available audio cable (RCA) for the AV |
•Use a commercially available signal cable
•Use a commercially available signal cable (Mini
•Use a commercially available signal cable (BNC) for the PC3 input terminals. Set BNC SELECT on the OPTION menu to PC (ANALOG) when using the PC3 input terminals. (See page 19.)
•Use a commercially available audio cable (mini stereo jack) for the PC audio input terminal. Use an audio cable without resistance.
TIPS
•Images may not be displayed properly depending on the computer (graphics board) to be connected.
•A screen with 1920 x 1080 resolution may not be displayed correctly on PC3 (BNC). In this case, check the settings of your computer (graphics board) to verify that input signals conform to specifications of this monitor (Hsync: 66.3 kHz, Vsync: 60 Hz, and Dot frequency: 148.5 MHz). (See page 35.)
•If there is a check box to disable EDID in display control panel, check it when using PC3 (BNC).
•Use the automatic screen adjustment when a PC screen is displayed for the first time using PC2 or PC3, or when the setting of the PC is changed. (See page 23.)
•The screen is adjusted automatically when SELF ADJUST in the OPTION menu is set to “ON”. (See page 19.)
audio input terminals. |
| ||
• The AV1 input terminal is compatible with the video signals | |||
below: |
|
|
|
1920 | x 1080 p | @ 50/59.94/60 Hz | |
1920 | x 1080 i | @ 50/59.94/60 Hz | |
1280 | x | 720 p | @ 50/59.94/60 Hz |
720 | x | 576 p | @ 50 Hz |
720 | x | 480 p | @ 59.94/60 Hz |
640 | x | 480 p | @ 59.94/60 Hz |
E10
