Installing the stand (supplied)
Caution
•Disconnect all cables from the monitor.
•Firmly tighten the installation screws (supplied) with the hex wrench (supplied).
•Ensure that you have sufficient space to work.
nAttaching the stand
Remove all packaging materials before starting work.
To prevent the table (etc.) from being damaged by the stand pedestal, spread a thick, soft cloth (blanket, etc.) and work on the cloth.
1.Insert the stand strut into the packaging material (upper left) as shown.
Packing material
(upper left)
Front
2.While supporting the stand pedestal with your hand, fasten to the stand strut with the supplied countersunk screws (M4 x 6 without washers) (x5).
Use the supplied hex wrench.
Countersunk screw
(M4 x 6 without washers)
5.Fasten the stand to the monitor with the supplied screws (M4 x 10 with washers) (x4).
Use the supplied hex wrench.
• Landscape
Screw
(M4 x 10 with washers)
• Portrait
Operation buttons
Screw
(M4 x 10 with washers)
Front
1
2
Pedestal
Insert by hooking the tab
Fixing pin
* A bag containing the screws (supplied) and hex wrench
(supplied) is attached to the round hole in the stand pedestal.
3.Spread a thick, soft cloth (blanket, etc.) that will prevent damage to the LCD panel on a stable flat surface where the entire monitor can be placed, and place the monitor with the LCD panel face down on the cloth.
4.Place the stand on the monitor.
Hook the tab on the stand under the mounting plate (pre- installed on monitor).
*If the monitor will be used in the portrait orientation, pull out the fixing pin (1), and insert it into the hole (2) as shown above.
*To remove the stand, place the monitor and stand as shown above and remove the screws.
Caution
•Adhere to the following when installing the monitor in its portrait orientation. Failing to adhere to the following may cause malfunctions.
-Install the monitor such that the operation buttons are located on the top side.
-Set the MONITOR on the MONITOR menu to PORTRAIT. (See page 20.)
Tab
E10
