Sharp PN-V602 Connection with the control kit optional, Connect the monitors in order

Connecting Peripheral Equipment

■ Connection with RS-232 cable

If you connect the monitor in a daisy chain using RS-232 cable, using the monitor buttons on the primary (main unit), settings are copied to the secondary (expansion unit) and operation from the primary can perform operation for all monitors. Setting each ID No. in the monitor is required.

1.Connect the monitors in order.

The first monitor will be set as primary (main unit) and the second monitor and beyond will be secondaries (expansion units).

Connect the RS-232C output terminal of the first monitor (primary) and the RS-232C input terminal of the second monitor (secondary) together using RS-232 cable (straight). Connect in the same way to the third and subsequent monitors. Up to 25 monitors can be connected. (Depending on the length of the cable used and the surrounding environment.)

First monitor: primary Second monitor: secondary

RS-232C	RS-232C	RS-232C
output terminal	input terminal	output terminal

RS-232 straight cable (commercially available)

Third monitor: connects to secondary RS-232C input terminal

2. Set the ID No.

Perform operation with the rear side buttons on the primary monitor. If you set AUTO ASSIGN ID No., located in the menu of the monitor to ON, the ID No. will be automatically assigned in order from the primary. (See page 24.)

(If you attach PN-ZR01 the control kit (optional), you can perform operation of the monitors with the remote control unit.)

■ Connection with the control kit (optional)

If performing operation of the monitor with the remote control unit, the PN-ZR01 control kit (optional) is required.

•Can perform operation of an arbitrary monitor or all monitors with the remote control unit of the first monitor.

•Can perform operation of up to 25 monitors.

•Connect the monitors together in a daisy chain with RS-232

cable.

Attach the remote control sensor box as shown in the following illustration.

*When attached to the left side, because the top and bottom for the remote control sensor box will be reversed

(the connection cable will be on top), the right side is recommended.

Caution

•When attaching the remote control sensor box, turn the main power switch OFF.

•Except for the remote control sensor box connection cable, do not insert any other cable into the control kit terminal. Also, do not connect any connection cables that have been extended with commercially available cables.

For the monitor in	For the monitor in
landscape orientation	portrait orientation

1.Insert the anti-rotation protrusion of the mounting bracket into the anti-rotation hole of the monitor.

2.Secure the stand angling hole of the monitor with the mounting screw.

3.Adjust the angle of the remote control sensor box, and secure it with the fixing screw, so that it may accurately receive signals from the remote control unit.

Stand angling hole

Remote control sensor box

Angle
adjustment
Fixing screw	Anti-rotation hole
	Anti-rotation protrusion
Mounting screw (short)
	Mounting bracket

4.Insert the remote control sensor box connection cable into the control kit terminal.

Remote control sensor box

Control kit terminal Connection cable

TIPS

•When you connect the remote control sensor box, the brightness sensor can be used.

The screen brightness will automatically change according to lighting conditions and the surrounding brightness. (See page 25.)

•Depending on where it has been placed or the surrounding conditions, the remote control sensor box may be affected by the brightness of the main unit screen and the brightness sensor may respond.

•Do not install the remote control sensor box in extremely bright or dark areas. The brightness sensor may not function properly.

Brightness sensor

E14