Menu Items
USER
Adjusts each item when the WHITE BALANCE is set to USER.
Adjusts | |
Adjusts | |
Adjusts | |
Adjusts | |
Adjusts | |
Adjusts |
COPY TO USER
Copies the value set for PRESET to the USER setting. Select “ON” and then press MENU .
GAMMA
Selects the gamma. USER sets the gamma to the sent value (see page 36). (In PIP mode, the main side setting is reflected in the image.)
When using LOCAL DIMMING, it controls the brightness per area. So, the gamma may differ from the set value.
LOCAL DIMMING
Automatically controls the backlight brightness per area according to the image. Increasing the level of this setting will result in higher contrast of the image, and will lower the monitor power consumption.
Light leakage and/or a
POWER LIMITED
Can be set when LOCAL DIMMING is HIGH. Set the value so that it is smaller than the set power consumption (see page 56.) by adjusting the brightness, etc.
DISPLAY COLOR PATTERN
Displays a color pattern. Can be displayed while the menu screen is displayed, so you can refer to the pattern while adjusting the image.
OFF | No pattern display. |
WHITE | White single color pattern display. |
RED | Red single color pattern display. |
GREEN | Green single color pattern display. |
BLUE | Blue single color pattern display. |
USER | Red/green/blue mixed color pattern display. |
| When USER is selected, set each color’s |
| level. |
RESET
Resets the values of the PICTURE menu items to the factory preset values.
Select “ON” and then press 
nAUDIO
TREBLE
Adjusts the volume of
BASS
Adjusts the volume of
BALANCE
Adjusts the balance of the audio sound between right and left.
RESET
Resets the values of the AUDIO menu items to the factory preset values.
Select “ON” and then press
nSETUP
OSD
Adjusts the horizontal display position of menu screen.
OSD
Adjusts the vertical display position of menu screen.
MONITOR
Select the installation direction of the monitor.
LANDSCAPE | Horizontal orientation |
PORTRAIT | Vertical orientation |
LANGUAGE
Sets the display language for the menu screen.
POWER ON DELAY
You can delay the screen display after the monitor is turned on. The period can be set up to 60 seconds in units of one second. When this function is activated, the power LED flashes (at approx. 1 second interval) in orange. This function is disabled when 0 is specified.
OPERATION MODE
MODE1......OFF IF NO OPERATION is set to ON, and
STANDBY MODE is set to LOW POWER. (These settings can not be changed.)
MODE2......Will perform standard operation.
OFF IF NO OPERATION is set to OFF, and STANDBY MODE is set to STANDARD. These settings can be changed.
STANDBY MODE
When STANDARD is selected, startup time from standby mode is reduced. Note, however that, more power will be consumed in standby mode.
When LOW POWER is selected, current consumption is reduced while the monitor is in standby mode. Note, however, that the startup time from standby mode becomes longer.
If set to LOW POWER, certain
OFF IF NO OPERATION
Determines whether or not to set the monitor to go into standby mode when there is no operation from the remote control unit,
HOT PLUG CONTROL
Sets whether to use hot plug control for the PC/AV HDMI and PC/AV
RS-232C/LAN SELECT
Selects the method with which to control the monitor from the computer.
ID No. SET
Assigns ID numbers to monitors connected in a daisy chain (see page 34), using the remote control unit or
The numbers 1 to 255 are available for ID numbers.
If “0” is set, the system regards this as the state where no ID number is set.
AUTO ASSIGN ID No.
ID No. to be used will be automatically assigned when multiple monitors are connected with
Select ON, then press MENU . Perform operations with the primary monitor.
E24
