Sharp PN-Y325 operation manual 27 E, Menu Items NAUDIO, Nsetup

Menu Items

nAUDIO

BASS

Adjusts the volume of bass-level sound.

TREBLE

Adjusts the volume of treble-level sound.

RESET

Resets the values of the AUDIO menu items to the factory preset values.

Select “ON” and then press ENTER.

nSETUP

DATE/TIME SETTING

Set the date and time. Press or to select the date and time, and press or to change the numerical values. Set the time on a 24-hour basis.

SCHEDULE (See page 30.)

You can turn the power on/off at a specified time.

Files in a USB flash drive can also be played at a specified time.

LANGUAGE

Sets the display language for the menu screen.

INPUT SELECT

HDMI

Select the input mode to be used in HDMI input terminals.

D-SUB

Select the input mode to be used in D-Sub input terminal. Select SET after selecting the input mode, and then press ENTER.

AUDIO OPTION

AUDIO OUTPUT

Sets the volume of sound output from the audio output terminals.

SPEAKER

Select whether or not speakers are used.

LAN Setup

Configures the settings to control the monitor from the computer via LAN. (See page 38.)

ID SETTING

Assigns ID numbers to monitors connected in a daisy chain (see page 33), using the RS-232 cables. The numbers 0 to 25 are available for ID numbers.

If “0” is set, the system regards this as the state where no ID number is set.

MULTI

ENLARGE (See page 29.)

Sets whether or not to use the enlarge function.

ADVANCED (ENLARGE)

ENLARGE H / ENLARGE V

..........Sets the number of screen splits (number of monitors) in the horizontal/vertical direction used for the enlargement.

ENLARGE-POS

..........Specify the split screen to be displayed when the enlargement function is used. (See page 29.)

BEZEL ADJUST

..........When ENLARGE is set to ON, sets whether or not to use the frame correction function.

THERMAL SENSOR SETTING

Select the installation direction of the monitor.

LANDSCAPE		Landscape orientation
PORTRAIT		Portrait orientation
OPERATION MODE
MODE1	OFF IF NO OPERATION is set to ON, and STANDBY MODE is set to LOW POWER.
	(These settings can not be changed.)
MODE2	Will perform standard operation. OFF IF NO OPERATION is set to OFF, and STANDBY MODE is set to
	STANDARD. These settings can be changed.

STANDBY MODE

When STANDARD is selected, startup time from standby mode is reduced. Note, however that, more power will be consumed in standby mode. When LOW POWER is selected, current consumption is reduced while the monitor is in standby mode. Note, however, that the startup time from standby mode becomes longer.

If set to LOW POWER, RS-232C commands cannot be used in standby mode and control via LAN is disabled. (See page 32, 38.) When set to LOW POWER, the monitor enters power standby mode rather than input signal standby mode when there is no input signal, and therefore the monitor does not wake up when a signal is input. (See page 17.)

27 E