Turning the power on/off

The power can be switched on by pressing the keys listed below. To turn off the power, press o.

Key

Display status upon start-up

oRestores the display as it was before the unit was switched off (Resume function).

mThe main menu screen appears.

dThe input screen or menu screen of each dictionary appears (Direct-

ton function)

u s y

Auto power off function

To save the battery, the PW-E500A will automatically turn its power off if no key operations are detected for a set period of time. The activation interval initial setting is 5 minutes, but it can be adjusted by following the directions on page 13.

To attach a commercially available strap

A carrying strap can be attached, as shown in the picture below (strap not included).

Caution:

• Do not swing the unit by the strap, or use excessive force to pull the strap. Doing so will cause a

malfunction or hardware damage to the unit.

Back of the unit

Backlight

This product has a built-in backlight, which allows you to view the display and use the product even in low-light conditions. Pressing , (Backlight) once illuminates the display until you have not pressed any keys for approx. 1 minute or press , again.

Note:

Use the backlight in low-light conditions. It will drain power from the operating batteries and significantly reduce battery life.

The backlight may remain on for less than 1 minute when is displayed.

Key notation used in this manual

All keys are framed (A, for instance); exceptions are found in the Calculator section, where the numeral entries are shown with real numbers.

Keys are often assigned with more than one function. The appropriate key/ function will be shown according to the input status.

<Example 1>

will be shown as either ‘Q’, ‘1’ or ‘1’ depending on the input status.

<Example 2>

will be shown as either ‘G’ or ‘+’ depending on the input status.

The functions indicated with green typeface are second functions. Press and release ^, then press an appropriate key.

<Example 1>

^ldirects to press and release ^, then press l(f).

^wdirects to press and release ^, then press w(<).

4

Page 5
Image 5
Sharp PW-E500A Turning the power on/off, Auto power off function, To attach a commercially available strap, Backlight