Sharp R-22GT Oven interior, Special note for R-25JT, Door, Air intake filter, Care And Cleaning

CARE AND CLEANING

Oven interior

1)For easy cleaning, wipe any spatters or spills with a soft damp cloth or sponge at the end of each day. For heavier spills, use mild soap and rinse thoroughly with hot water.

2)At least once a week, remove the splash cover and wash in a mild detergent solution. The splash cover is located in the top of the oven and may easily be removed.REMEMBER TO UNPLUG THE POWER CORD.

Remove two thumb screws (A) as shown in Fig. 1. Then remove the splash cover from the oven.

To replace the splash cover, insert two projec- tions of the cover (B) into the holes of the oven cavity backplate as shown in Fig. 2. And se- cure the cover to the oven celing with two thumb screws (A) as shown in Fig.1.

Special note for R-25JT

The splash cover can be separated into two pieces for easy cleaning as shown in Fig. 3. After cleaning, make sure to put (C) in (D) and replace the splash cover.

3)Wipe any grease, spills or spatters on the door seal surfaces with a soft damp cloth or sponge so that they do not build up. The door seals must always be free of grease and spatters so that the door closes properly.

Door

Wipe the door and window on both sides fre- quently with a damp cloth to remove any spills or spatters. Always keep the door seals and seal surfaces clean so that any grease, spills or spat- ters are not allowed to build up. Such a build-up could result in leakage of microwave energy from the oven.

Air intake filter

Hole

Oven

Hole

Clip Air intake filterClip

Keep the air intake filter clean. Clean at least every two weeks or more often for heavy use. Remove the air intake filter by pulling the two (2) clips on the sides of the filter.

Wash the air intake filter in mild soapy water, rinse and dry with a soft cloth.

After cleaning re-install the air intake filter.

Fig.2

Door	Fig.1	Splash cover
	(A)

Fig.3 (for R-25JT only)

(C)

Splash cover

(B)

Hole

(D)

15