Sharp R-25JT, R-22GT, R-24GT Grounding Instructions, Voltage Select, Radio or TV Interference

GROUNDING INSTRUCTIONS

GROUNDING INSTRUCTIONS

This appliance must be grounded. In the event of an electrical short circuit, grounding reduces the risk of electric shock by providing an escape wire for the electric current. This appliance is equipped with a cord having a grounding wire with a grounding plug. The plug must be plugged into an outlet that is properly installed and grounded.

WARNING – Improper use of the grounding plug can result in a risk of electric shock. The electrical requirements are 120 Volt, 60 Hz AC only, 20 Amp or more (R-22GV,R-22GT); 230/208 Volt, 60 Hz, AC only, 15 Amp or more (R-23GT) and 20 Amp or more (R-24GT, R-25JT) fused electrical supply. It is recommended that a separate circuit serving only this appliance be provided. When installing this appliance, observe all applicable codes and ordinances. If it is necessary to use an extension cord, use only a 3-wire extension cord that has a 3-blade grounding plug and a 3-slot receptacle that will accept the plug on the appliance. The marked rating of the extension cord should be AC 120 Volt 20 Amp (R-22GV,R- 22GT), AC 230/208 Volt 15 Amp (R-23GT), AC230/208 Volt 20 Amp (R-24GT, R-25JT). Consult a qualified electrician or serviceman if the grounding instructions are not completely understood or if doubt exists as to whether the appliance is properly grounded.

Receptacle Box Cover

Receptacle Box Cover	3-Pronged plug
3-Pronged plug	(6-15P)
(5-20P)	3-Pronged, Receptacle
3-Pronged, Receptacle	(6-15R)
(5-20R)	230/208V 15A
120V 20A	R-23GT
R-22GV,R-22GT

Radio or TV Interference

Should there be any interference caused by the microwave oven to your radio or TV, check that the microwave oven is on a different electrical circuit, relocate the radio or TV as far away from the oven as feasible or check position and signal of receiving antenna.

Receptacle Box Cover

3-Pronged plug (6-15P) R-24GT

(6-20P) R-25JT

3-Pronged, Receptacle (6-20R)

230/208V 20A R-24GT, R-25JT

VOLTAGE SELECT

The R-23GT, the R-24GT and the R-25JT have been preset for 230V operation.

If you need to change this oven for 208V operation, follow instructions below.

1.Unplug oven.

2.Remove one screw(A) from the Voltage Select Cover located on back of the oven near the bottom.

3.Remove the Voltage Select Cover and rotate 180 degrees.

4.Reinstall the Voltage Select Cover using one screw(A) removed in Step 2.

5.Plug power cord into wall outlet.

Your oven is now ready for 208V, 60Hz operation.

Note: If “EE4” or “EE5” appear in the lighted digital display, a voltage adjustment must be made.

208 V

230 V (A)

230 V 208 V

5