Sharp R-530D, R-430D operation manual E a N I N G a N D C a R E, Demonstration Mode, Help

O T H E R C O N V E N I E N T F E A T U R E S

DEMONSTRATION MODE

To demonstrate, touch Clock, the number 0 and then touch Start/Touch On pad and hold for 3 seconds.

DEMO ON will appear in the display. Cooking opera- tions and specific special features can now be demon- strated with no power in the oven. For example, touch Minute Plus pad and the display will show 1.00 and count down quickly to END .

To cancel, touch Clock, then the number 0 and Stop/ Clear pads. If easier, unplug the oven from the electrical outlet and replug.

HELP

Each setting of Sensor Cooking and More from your Microwave has a cooking hint. If you wish to check, touch Custom Help pad whenever HELP is lighted in the Interactive Display for these hints.

C L E A N I N G A N D C A R E

Exterior

The outside surface is painted. Clean the outside with mild soap and water; rinse and dry with a soft cloth. Do not use any type of household or abrasive cleaner.

Door

Wipe the window on both sides with a damp cloth to remove any spills or spatters. Metal parts will be easier to maintain if wiped frequently with a damp cloth. Avoid the use of spray and other harsh cleaners as they may stain, streak or dull the door surface.

Touch Control Panel

Care should be taken in cleaning the touch control panel. If the control panel becomes soiled, open the oven door before cleaning. Wipe the panel with a cloth dampened slightly with water only. Dry with a soft cloth. Do not scrub or use any sort of chemical cleaners. Close door and touch Stop/Clear pad.

Interior

Cleaning is easy because little heat is generated to the interior surfaces; therefore, there is no baking and setting of spills or spattering. To clean the interior surfaces, wipe with a soft cloth and warm water. DO NOT USE ABRASIVE OR HARSH CLEANERS OR SCOURING PADS. For heavier soil, use baking soda or a mild soap; rinse thoroughly with hot water.

NEVER SPRAY OVEN CLEANERS DIRECTLY ONTO ANY PART OF THE OVEN.

Waveguide Cover

The waveguide cover is made from mica so requires special care. Keep the waveguide cover clean to as- sure good oven performance. Carefully wipe with a damp cloth any food spatters from the surface of the cover immediately after they occur. Built-up splashes may overheat and cause smoke or possibly catch fire. Do not remove the waveguide cover.

Odor Removal

Occasionally, a cooking odor may remain in the oven. To remove, combine 1 cup water, grated peel and juice of 1 lemon and several whole cloves in a 2-cup glass measuring cup. Boil for several minutes using 100% power. Allow to set in oven until cool. Wipe interior with a soft cloth.

Turntable/Turntable Support

The turntable and turntable support can be removed for easy cleaning. Wash them in mild, sudsy water; for stubborn stains use a mild cleanser and non abrasive scouring sponge. They are also dishwasher-proof. Use upper rack of dishwasher. The turntable motor shaft is not sealed, so excess water or spills should be wiped up immediately.

Turntable

Exterior Interior Turntable Support

24