A33271,Middle East R750D,EN O/M
INSTALLATION INSTRUCTIONS
1.Remove all packing materials from the oven cavity. Check the unit for any damage such as a misaligned door, damaged door seals around the door or dents inside the oven cavity or on the door. If there is any damage, please do not operate the oven until it has been checked or approved by the SHARP SERVICE CENTRE and repaired, if necessary.
2.Provided accessories include:
1)Turntable
2)Turntable support
3)High rack
4)Low rack
5)Operation manual
6)Cookbook
3.Since the door may become hot during cooking, and in order to avoid its accidental touch, the oven should be placed at least 80 cm or more above floor. You should also keep children away from the door to prevent them burning themselves.
4.Fit the turntable support to the turntable motor shaft on the floor of the oven cavity and place the turntable on the turntable support. Make sure the turntable and turntable support are centrally located and locked together. NEVER operate the oven without the turntable support and turntable.
5.The oven should not be installed in any area where heat and steam are generated, for example, next to a conventional oven unit.
The oven should be installed so as not to block ventilation openings.
Allow at least 40 cm on top of the oven for free air space. This oven is not designed to be
6.Neither the manufacturer nor the distributors can accept any liability for damage to the machine or personal injury for failure to observe the correct electrical connecting procedure.
The A.C. voltage and frequency must correspond to the one indicated on the rating label.
7.This appliance must be earthed:
IMPORTANT
The wires in power supply cord are coloured in accordance with the following code:
: | Earth | |
Blue | : | Neutral |
Brown | : | Live |
As the colours of the wires in the power supply cord of this appliance may not correspond with the coloured marking identifying the terminals in your plug, proceed as follows:
The wire which is coloured 
or coloured green or
The wire which is coloured blue must be connected to the terminal which is marked with the letter N or coloured blue.
The wire which is coloured brown must be connected to the terminal which is marked with the letter L or coloured brown.
E – 3
3 | 2/10/04, 6:43 PM |
