45
Entering character codes with numeric keys on the keyboard
Numerals, letters and symbols are programmable by entering the character code and the :key. (If numeric
characters entry is selected, “1” is displayed on the operator display (lower line). Press the Nkey to release
it.) Set the alphanumeric character code table on the next page. By doing this, you can program characters
other than those on the key tops.
• Double-size characters can be made by entering the character code 253 or pressing the Wkey. “W” is
displayed when double-size characters entry is selected as shown in the operator display example below.
• All three digits of the character code MUST be entered (even if it starts with zero).
Operator display (Example)
To program the word “SHARP” in double-size characters
When you press an appropriate number key (job code number) and press the Pkey for text entry just after you
start programming with the skey, the cash register will automatically be ready for text entry.
253 :083 :072 :065 :082 :080 :
S H A R P
PGM
01 W 065
Character code
=A PGM
01 W 02
Characters: Indicating double size character of “A”
Number of characters
programmed
Press of
253 : 065
Press of
:
Cursor
Department code, PLU code, UPC code, function number,
clerk code or logo message line number is displayed here.
(UPC code will disappear when H, N or W is pressed.)
Characters entered are displayed here.
A406_3 FOR THE MANAGER 09.10.14 9:03 AM Page 45