(2) When the system retry function is enabled
If a transmission error relating to a satellite occurs, the relevant window will appear on the display of the master and the master awaits entry of one of the following commands:
A)RETRY command (selection from the menu)
B)ABORT command (selection from the menu)
C)IGNORE command (selection from the menu)
A)RETRY command:
When RETRY is selected, the master retries to access the satellite; however, depending on the type of error (command error, etc.), it is obvious that the master would fail to access it again. If this type of error occurs during transmission, the master may not retry.
B)ABORT command:
When ABORT is selected, the master terminates access to the satellite and regards the transmission as having unsuccessfully ended. However, in the case of program data downloading, the ABORT command may be issued only when all the satellites accessed are in the error state.
C)IGNORE command:
When IGNORE is selected, the master terminates access to the satellite and regards the transmission as having successfully ended, and then prints only transmitted data.
If no satellite has successfully transmitted data, the IGNORE command may be issued to the master in the case of sales data inquiry (X report), though the result is not printed.
[Retry during sales data inquiry]
During resetting, the ABORT command may be given only when every accessed satellite is in the error state. The IGNORE and RETRY commands are available unconditionally.
56
