CUSTOMISED INSTALLATION
MANUALLY TUNING A CHANNEL
•It should not be necessary to tune in a broadcast channel manually except in unusual circumstances such as poor signal.
To manually tune in a channel follow the procedure below.
1.Press MENU .
2.Press the [ / ] menu select buttons to select SET UP. Press SET SET to confirm.
3.CHANNEL PRESET will be highlighted. Press SET SET .
4.Press [ / ] to select CHANNEL.
5.VC-MH705LM only
IMPORTANT NOTE:
Press to select CH or CC. This will determine whether off air (CH) or cable
(CC)is tuned first. Note that both off air and cable will be tuned regardless of the setting.
6.Press [ / ] to start tuning in either direction. Tuning will stop when a channel
is received. If it is not the desired channel, press [ / ] to continue tuning.
7.Press [ / ] to select FINE TUNING. Press and hold [ / ]until the sharpest colour picture is obtained.
IMPORTANT NOTE
8.If you connect an independent decoder,
you must press [ / ] to select DECODER, then select [ / ] to turn the decoder function ON.
9.Press [ / ] to select SKIP.
The SKIP function determines whether the channel can be selected when using the
CHANNEL / instead of the
NUMBER BUTTONS.Press [ / ]
to select ON or OFF for this option.
SET
10.Press SET to confirm.
11.Press MENU to leave this function.
C H A N N E L P R E S E T
C H A N N E L S O R T
C L O C K
➔P R E S E T |
| 1 |
CHANN E L | CH 2 1 | |
F I N E T UN I NG | ▲ | ▲ |
D E COD E R | ON | O F F |
S K I P | ON | O F F |
CABLE RECEPTION
Station | Real | ||
Channel | |||
Signals | VHF | ||
Numbers | |||
|
| ||
|
|
| |
A |
| 01 | |
B |
| 02 | |
C |
| 03 | |
D |
| 04 | |
E |
| 05 | |
F |
| 06 | |
G |
| 07 | |
H |
| 08 | |
J |
| 09 | |
|
|
|
www.sharp.co.uk/support
28