Sharp VL-A10H Installing the Lithium, Memory Battery, Removing the Lithium Battery

Installing the Lithium	5 Close the cassette compartment door by
Memory Battery	pressing the centre until it clicks into
	place.

The supplied lithium battery is used to store the memory of the date and time settings.

1 Slide the cassette compartment door release and open the cassette compartment door.

Cassette compartment
door release	Removing the Lithium Battery
	Perform steps 1 and 2 above, then lift out the
	battery from the battery holder.
	Note:
	• Replace the battery with a new CR2025 battery
	when the date and time indicator starts to fall
	behind the correct time.
Note: The cassette holder will extend and	Notes on the Use of the Lithium
open when the VIEWCAM is connected to a	Battery
power source. Be sure to close the cassette
holder before proceeding to the next step	CAUTION: Danger of explosion if battery is
(see page 11).
	incorrectly replaced. Replace only with the
2 Pull out the lithium battery holder using	same or equivalent type CR2025 recommended
	by the equipment manufacturer.
a pointed object such as the tip of a	WARNING KEEP THIS BATTERY AWAY FROM
ballpoint pen.
	CHILDREN. IF SWALLOWED, CONSULT A
	PHYSICIAN IMMEDIATELY FOR EMERGENCY
	TREATMENT.
	CAUTION BATTERY MAY EXPLODE IF MIS-
	USED OR INSTALLED WITH POLARITY
	REVERSED. DO NOT RECHARGE, DISAS-
	SEMBLE OR DISPOSE OF IN FIRE.

Preparation

Lithium battery holder

3 Insert the lithium battery into the battery holder with the ` side of the battery facing the j side of the holder.

j mark

4 Push the battery holder back into position.

•Do not short-circuit, recharge, disassemble, or heat the lithium battery.

•Should the lithium battery leak, wipe the battery compartment and holder clean, and then insert a new battery.

•The lithium battery will last about one year of normal usage.

12