Sharp VL-A10H Editing, Cutting Unwanted Sequences, Setting Edit Mode, To stop editing

Advanced Features

Editing

Video editing lets you refine your videos by removing unwanted sequences from your tape, or transposing one sequence with another. This VIEWCAM lets you monitor the source pro- gram on the built-in LCD monitor without having to connect it to an external TV or video monitor.

Connect the VIEWCAM to a VCR with the sup- plied audio/video cable, as shown.

	Yellow: To VIDEO IN jack
Recording	White: To AUDIO IN (L) jack

Audio/video cable (supplied)

Playback

To VIDEO jack (ø2.5)

To AUDIO jack (ø3.5)

Note:

•If your VCR has a 21-pin Euro-SCART connector, use the RCA/21-pin Euro-SCART conversion connector (QSOCZ0033TAZZ) available from our main parts distributor detailed on page 53.

Cutting Unwanted Sequences

1 Play back the tape to be edited, and locate the beginning and end of the sequence you wish to cut. Write down the tape counter readings at the beginning and end of that sequence (see page 35). Then rewind the tape to the beginning of the portion that you wish to keep.

2 Load a video cassette into the recording VCR.

3 Set the Power switch on the VIEWCAM to VCR. Press the PLAY button (D) on the VIEWCAM and the Record button on the VCR at the same time.

4 Press the Pause/Still button on the VCR to pause recording when the source tape reaches the beginning of the sequence to be cut.

5 Press the Pause/Still or Record button on the VCR to resume recording when the source tape reaches the end of the sequence to be cut.

To stop editing

Press the Stop buttons on the VIEWCAM and the VCR.

Notes:

•Some of the transitions between edited sequences may be slightly off.

•There may be picture noise during video search or still picture playback. This does not imply a defect in the VIEWCAM.

Setting Edit Mode

Advanced Features

21-pin Euro-SCART on VCR

0RCA/21-pin Euro-SCART conversion connector

VIDEO AUDIO	AUDIO	(QSOCZ0033TAZZ)
(L/MONO)	(R)
Video		Audio L

Picture quality inevitably decreases when dubbing from the VIEWCAM to a VCR. To minimize the quality reduction, set the VIEWCAM to Edit mode.

1 Set the Power switch to VCR, then press

the MENU button until appears.

2 Press the ￿ or ￿ button to select “EDIT”, then press the SET button (B) to select “ON”.

	Notes:
	• The EDIT mode does not function when the
	VIEWCAM is recording.
	• After you finish editing, set the EDIT menu item back
47	to “OFF”.