Installing the Battery to Remote Control (VL-Z5 only)

The CR 2025 type lithium battery supplied with VL-Z5 is used to power the remote control unit.

1 Hold the remote control facing down, and pull out the battery holder while pressing the tab toward the centre.

Tab

2 Insert the larger lithium battery into the battery holder with the Hside of the battery facing the mside of the holder.

Hside, CR 2025 type lithium battery

m” side

Notes on the Use of the Lithium battery

CAUTION: Danger of explosion if battery is incorrectly replaced. For camcorder, replace only with same or equivalent type CR1216, for remote control unit, replace only with same or equivalent type CR2025, both recom- mended by the equipment manufac- turer.

XKEEP THIS BATTERY

AWAY FROM CHILDREN. IF SWAL- LOWED, CONSULT A PHYSICIAN IMMEDIATELY FOR EMERGENCY TREATMENT.

ZBATTERY MAY EXPLODE IF MISUSED OR INSTALLED WITH POLARITY REVERSED. DO NOT RECHARGE, DISASSEMBLE OR DISPOSE OF IN FIRE.

Do not short-circuit, recharge, disassemble, or heat the lithium battery.

Should the lithium battery leak, wipe the battery compartment clean, and then insert a new battery.

The lithium batteries will last about one year under normal usage.

Preparation

3 Insert the battery holder back into position.

13

Page 23
Image 23
Sharp VL-Z5E Installing the Battery to Remote Control VL-Z5 only, Insert the battery holder back into position