Sharp XG-C435X-L, XG-C465X-L Image Projection, Using the Adjustment Feet, Basic Operation

Image Projection

Using the Adjustment Feet

The height of the projector can be adjusted using the adjustment feet when the screen is located higher than the projector, the screen is inclined or when the installation site is slightly inclined.

Install the projector so that it is as perpen- dicular to the screen as possible.

Side View Top View

Lens center

1Press the Height Adjustment but- tons.

•The adjustment feet come out.

2Lift the projector to adjust its height and remove your hands from the Height Adjustment but- tons.

•The projector is adjustable up to approxi- mately 9 degrees.

3Rotate the Tilt dial to finely ad- just the horizontal tilt of the pro- jector.

•The inclination is adjustable within ap- proximately 2 degrees.

•When adjusting the height of the pro- jector, trapezoidal distortion occurs. When “Auto V-Keystone” of the “SCR- ADJ” menu is set to “On” (see page 49), keystone correction functions automati- cally to correct trapezoidal distortion. When you want to adjust the automati- cally corrected image, use the manual keystone correction. (See page 32.)

Info

•Do not press the Height Adjustment button when the adjustment feet come out without firmly holding the projector.

•Do not hold the lens when lifting or lower- ing the projector.

•When lowering the projector, be careful not to get your fingers caught in the area be- tween the adjustment foot and the projector.

Adjustment foot

Height Adjustment button

Tilt dial

Basic Operation

-31