Helpful Functions Set during Installation (ÒPRJ-ADJÓ menu)
8Selecting the Transmis- sion Speed (RS-232C)
Make sure that both the projector and computer are set for the same baud rate.
Selectable items | Description | |
9600 bps | Transmission speed is slow. | |
|
|
|
38400 bps |
|
|
|
| |
|
|
|
115200 bps | Transmission speed is rapid. | |
|
|
|
Note
•Refer to the “SETUP MANUAL” contained on the supplied
•Refer to the computer’s operation manual for instructions for setting the computer’s baud rate.
9Fan Mode Setting
This function changes the fan rotation speed.
Selectable items | Description |
Normal | Suitable for normal environments. |
High | Select this when using the projector at |
| altitudes of approximately 1,500 meters |
| (4,900 feet) or more. |
When “Fan Mode” is set to “High”, the fan rotation speeds up, and the fan noise becomes louder.
0System Lock Function
This function prevents unauthorized use of the projector. Once this function is activated, users must enter the correct keycode each time the pro- jector is turned on. We suggest you record the keycode in a safe place where only autho- rized users have access.
Info
•If you lose or forget your keycode, contact your nearest Sharp Authorized Projector Dealer or Ser- vice Center (see page 68). Even if the product warranty is valid, the keycode reset will incur a charge.
Menu operation Page 43
Setting/Changing the keycode
1Select ÒSystem LockÓ, then press ENTER or .
2Select ÒNextÓ, then press ENTER.
•The screen for entering the keycode appears.
3Press the 4 buttons on the remote control or on the projector to enter the preset keycode in ÒOld CodeÓ.
•When setting the keycode for the first time, press " on the projector for four times.
|
|
|
| |||||
| Setting the System Lock |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
| Old Code |
| – | – | – | – |
| |
| New Code |
| – – – – |
| ||||
| Reconfirm |
| – – – – |
| ||||
|
|
|
|
|
|
|
|
|
Note
•If you input a wrong keycode, the cursor returns to the first point of the “Old Code”.
•The preset keycode is 4 " buttons on the projector. When you press the " button four times, the keycord input screen disappears.
4Press the 4 buttons on the remote control or on the projector to enter the new keycode in ÒNew CodeÓ.
Note
•You cannot use the following buttons for keycode: STANDBY/ON, ON, STANDBY,
ENTER,
•System lock function recognizes each button on the remote control or on the projector as an individual button, even if they share the same button name. If you used the buttons on the projector in set- ting your keycode, the keycode cannot be canceled with the remote control.
|
|
|
| |||
Setting the System Lock |
|
|
|
|
| |
| Old Code | * * * * |
| |||
| New Code |
| – | – – – |
| |
| Reconfirm |
| – – – – | |||
|
|
|
|
|
|
|