Regarding the Lamp
Removing and Installing the Lamp Unit
Warning!
•Do not remove the lamp unit from the pro- jector right after use. The lamp and parts around the lamp will be very hot and may cause burn or injury.
Info
•Do not touch the glass surface of the lamp unit or the inside of the projector.
•To avoid injury to yourself and damage to the lamp, make sure you carefully follow the steps below.
•Do not loosen other screws except for the lamp unit cover and lamp unit.
Optional | Lamp unit |
accessory |
STANDBY/ON button
1Press STANDBY/ON on the projector or STANDBY on the remote control to put the projec- tor into standby mode.
•Wait until the cooling fan stops.
2Disconnect the power cord.
•Unplug the power cord from the AC socket.
•Leave the lamp until it has fully cooled down (about 1 hour).
3Remove the lamp unit cover.
•Loosen the user service screw (1) that
secures the lamp unit cover. Slide down (2) and remove the lamp unit cover (3).
4Remove the lamp unit.
•Loosen the securing screws from the lamp unit. Hold the lamp unit and pull it in the direction of the arrow. At this time, keep the lamp unit horizontal and do not tilt it.
AC socket
2 3
1
User service screw (for lamp unit cover)
Securing screws