Sharp XR-50S, XR-55X appendix Turning the Projector On/Off, Basic Operation, Info

Turning the Projector On/Off

Turning the Projector On

Note that the connections to external equipment and power outlet should be done before performing the operations written below. (See pages 21 to 24.)

Open the lens shutter fully and press STANDBY/ON on the projector or ON on the remote control.

•The power indicator illuminates green.

•After the lamp indicator illuminates, the projector is ready to start operation.

Note

•About the Lamp Indicator

The lamp indicator illuminates to indicate the status of the lamp.

Green: The lamp is on.

Blinking in green: The lamp is warming up.

Red: The lamp is shut down abnormally or the lamp should be replaced.

•When switching on the projector, a slight

fl ickering of the image may be experienced within the fi rst minute after the lamp has been illuminated. This is normal operation as the lamp's control circuitry is stabilising the lamp output characteristics. It should not be regarded as faulty operation.

•If the projector is put into Standby mode and immediately turned on again, the lamp may take some time to start projection.

•When System Lock is set, the keycode input box appears. To cancel the keycode setting, input the keycode that you have already set. See page 50 for details.

Info

•When “Auto Restart” is set to “On”:

If the power cord is unplugged from the outlet or the breaker switch is turned off when the projector is on, then the projector automatically turns on when the power cord is plugged into the AC outlet or the breaker switch is turned on. (See page 49.)

•English is the factory default language. If you want to change the on-screen display to another language, change the language according to the procedure on page 48.

Power indicator Lamp indicator

STANDBY/ON button

STANDBY button

ON button

On-screen display (confirmation message)

Basic Operation

Turning the Power Off (Putting the Projector into Standby Mode)

Press STANDBY/ON on the projector or STANDBY on the remote control, then press that button again while the confirmation message is displayed, to put the projector into Standby mode.

• The projector cannot be turned on while cooling.

Info

•Direct Power Off function:

You can unplug the power cord from the AC outlet even if the cooling fan is still running.

25