Assembly

Cutting Attachment Shield

Socket-

Bracket

 

Head Cap

Outer

Screw

Tube

 

Shim

Clamp Screw

 

 

Shim

Retaining Nut

Cutting

Cutting Attach-

 

Attachment Mounting

 

ment Shield

 

Plate

 

 

Figure 9

Cutting Attachment Shield

Line Cutter

 

 

Sub-shield with

Figure 9A

Line Cutter

 

Install the Cutting Attachment Shield C2510.

1.Insert the cutting attachment shield between the outer tube and the cutting attachment mounting plate. See Figure 9.

NOTE:

It may be necessary to loosen the retaining nut and clamp screw to adjust cutting attach- ment shield mounting plate.

2.Fit the two shims and the bracket over the outer tube and loosely install the four socket-head screws. See Figure 9.

3.Tighten the four socket-head cap screws to secure the cutting attachment shield.

CAUTION!

Make sure the clamp screw and retaining nut are securely tightened before tightening the four socket-head cap screws.

WARNING!

NEVER operate the unit without the cutting attachment shield installed and tightly secured!

Sub-Shield C2510.

(when trimmer head is in use)

1.Attach the shield extension to the cut- ting attachment shield. See figure 9B.

WARNING!

NEVER use this machine without sub-shield when using a trimmer head.

Cutting Attachment Shield

Hook

Receiver

Hook Sub-shield

Figure 9B

CAUTION!

Make sure the sub-guard is com- pletely hooked at the hook receiver.

Page 6
Image 6
Shindaiwa 81704 manual Assembly, Install the Cutting Attachment Shield C2510, Sub-Shield C2510