Chapter 5:Connection Mode
For a router with a direct connection to the Router’s local Router, the Gateway IP Address is the address of the Router’s local router.
For routers which must forward packets to another router before reaching the Router’s local router, the Gateway IP Address is the address of the intermediate router.
Example – Static Route
Here provides you an example of Static Route.
For the Router’s Routing Table
For the LAN shown above, with 2 routers and 3 LAN segments, the Router requires to add 2 static routes as follows:
ADSL Router | Destination | 192.168.10.0 |
| Subnet Mask | 255.255.255.0 (Standard Class C) |
| Gateway | 192.168.1.254 (Router B) |
IP Routing – Dynamic Routing
Routing Information Protocol (RIP) is utilized as a means of exchanging routing information between routers. It helps the routers to determine optimal routes. This page allows you to enable/disable this function.
RIP Version:
It incorporates the RIP information when receiving and broadcasting the RIP packets. From the drop down list, select a RIP version to be accepted, 1, 2 or both.
Operation Mode:
There are two modes for you to choose, Active and Passive. Select Active for transmitting and receiving data, or select Passive for receiving data only.
Enabled:
Click Enabled to enable the RIP function on
