Siemens programming the cpu 314c-2dp manual Foreword, To 3 days Module C To 3 days Module D

Automation and Drives - SCE

1.FOREWORD

In terms of its contents, module A5 belongs to the teaching unit entitled "Basic Principles of STEP

7 Programming'.

Basic Principles of

STEP 7 Programming

2 to 3 days Module A

Further Functions of STEP 7 Programming 2 to 3 days Module B

Progamming	Industrial Field
Languages	Bus Systems
2 to 3 days Module C	2 to 3 days Module D

Plant Simulation with SIMIT SCE

1 to 2 days Module G

Process

Visualization

2 to 3 days Module F

Frequency Converter at SIMATIC S7

2 to 3 days Module H

IT Communication with SIMATIC S7

2 to 3 days Module E

Learning Objective:

In this module, the reader learns how to create a hardware configuration for the CPU 314C-2DP and how to write and test a STEP 7 program. Based on the steps below, the A5-module explains the procedure in principle, using a very brief example:

•Setting up a STEP 7 project

•Creating the hardware configuration for the 314C-2DP CPU

•Writing a STEP 7 program

•Testing the program

Requirements:

The following knowledge is a precondition for successful utilization of this module:

•Knowledge in the use of Windows

•Basic principles of PLC programming with STEP 7 (e.g. Module A3 – 'Startup' PLC Programming with STEP 7)

	Foreword	Notes	Hardware configuration	STEP 7 program	Testing
T I A Training Document			Page 4 of 25		Module
					A5
Issue date: 02/2008				Programming the CPU 314C-2DP