10

Getting started

Charge battery

The battery is not fully charged when delivered. Plug charger cable into the bottom of the phone, plug power supply unit into a power socket and charge for at least two hours.

Display when charging is in progress

h

During charging.

Charging time

An empty battery is fully charged after about 2 hours. Charging is only possible in an ambient temperature of 41 °F to 104 °F (the charge icon flashes as a warning when the temperature is 41 °F above/below this range). The voltage specified on the power supply unit must not be ex- ceeded.

To obtain maximum performance from the battery, it must be fully charged and then emptied at least five times.

Charge icon not visible

If the battery is totally discharged, no charge icon is displayed when the charger is plugged in. It will appear after two hours at most. In this case the battery is fully charged after 3-4 hours.

Only use the charger provided!

Display while in service

Charge level display during opera-

tion (empty-full):

a d g

A beep sounds when the battery is nearly empty. The battery level is only shown correctly during an unbroken charging/discharging cycle. You should therefore not remove the battery unnecessarily and where possible not finish the loading process early.

Note

The charger heats up when used for long periods. This is normal and not dangerous.

Performance...............................

page 118

Battery quality statement............

page 114

Note

Your phone's display is delivered with a protective film.

Remove this film before getting started.

In rare cases, the static discharge may cause discoloration at the edges of the display. However this will disappear within 10 minutes.