Power Consumption @12V DC, Dimensions | Sierra Wireless X HSUPA

Specifications

Power Consumption: (@12V DC)

•Transmit/Receive (Typical/Max) 300/520 mA

•Idle 170 mA

•Low Power Mode 80 mA

•Input Voltage 9 ‐ 28V DC

Standards/Approvals

•Carrier specific approvals

•CE

•FCC

•PTCRB

•Industry Canada

Host Interfaces

•Ethernet: 10/100 Mbps RJ‐45

•USB Type B

•RS‐232: DB‐9 DCE (300‐230400 baud)

•I/O: 4 Digital, 4 Analog, 2 Relay

•Antenna Connection:

·Cellular ‐ 50 Ohm TNC

·GPS ‐ 50 Ohm SMA

Warning: The antenna should be installed no closer than 20 cm from the human body. It is one of the RSS-102 requirements for devices not requiring SAR.

Dimensions

•162mm x 40mm x 109mm

•612 grams

Application Interfaces

•TCP/IP, UDP/IP, DHCP, HTTP, SNMP, SMTP, SMS, MSCI, NMEA, TAIP, GPS, and more

LED Indicators

•Network

•Signal

•Activity

•Service

•GPS


Rev 4.0 Oct.09						12
Rev 4.0 Oct.09						12

Image 18

Sierra Wireless X HSUPA manual Power Consumption @12V DC, Standards/Approvals, Host Interfaces, Dimensions, LED Indicators

Contents

User Guide Important Notice Safety and Hazards Limitation Liability Patents Copyright Trademarks Contact Information Revision History Contents Activating PinPoint X on your cellular provider Introduction to the PinPoint Hsupa Aleos ACEware Simplified Deployment Monitor and Control Connecting to your cellular provider Modem DoctorSteps of a connection Cellular Dynamic vs. Static IP Addresses Communication Hsupa Hsupa Connection methods Umts Networking Virtual serial portIPSec Applications SoftwareEvents Reporting Documentation Tools and Reference Documents Technology SpecificationsFeatures and Benefits Bands LED Indicators Power Consumption @12V DCDimensions Standards/Approvals Interface Port Pin-Outs Serial PortPort Power Connector Power Connector not to scale Before you start Installing the SIMActivating PinPoint X on your Cellular provider Cellular Account Required Ejecting the SIM tray Opening the SIM SlotRemove the SIM from the card Tools Required Finishing the SIM installation Insert the SIM into the TrayInsert the Tray and SIM Configuring the APN Hardware Installation PinPoint Dust, etc Connecting to Power GPS Antenna Placement for a Vehicle Connecting to a Computer or other Device Ignition Sense power connector Serial Indicator Lights Rssi LED Ranges RSSI/Signal LED Status Ranges of Rssi dBm Mounting Light Patterns Front Inputs, Relay Outputs, and Power 5 Status Capturing External EventsAnalog Inputs Digital Inputs Relay Outputs Connecting devices to the I/O Port Rev 4.0 Oct.09 Inputs, Relay Outputs, and Power Status Wiring Color Corospondance Power Modes and Information Monitoring and Setting the I/OGetting Immediate Reports Using RAP Wiring the PinPoint X for Power Effect on Modem State Monitoring Power-In Voltage PinPoint X Hsupa 20080311