2.At the Found New Hardware Wizard:
XP (w/SP1 or earlier)/Server 2003: continue to step #3.
XP (w/SP2 or later)/Server 2003 (w/ SP1 or later): select No, not at this time, then click Next.
3.Insert the driver CD, select Install the software automatically (Recommended), and click Next.
4.Click Finish and restart Windows to complete the installation.
Windows XP / Server 2003 (64-bit)
For New Installation
A new installation requires a floppy disk for the driver installation. To make this floppy disk, copy the contents of the 64bit folder, found on the driver CD, onto a blank floppy disk then follow the directions below.
1.Install the board and follow Microsoft procedures to install Windows accordingly.
2.At the Windows Setup screen, press F6 to install the driver.
3.Insert the floppy disk that you made above. Press S then press Enter.
4.Select Silicon Image SiI... that matches your system processor, then press Enter.
5.Press Enter to continue and follow the
Note: If prompted, press Continue Anyway several times to install the driver.
For Existing Installation
1.Install the board and boot up Windows.
2.At the Found New Hardware Wizard, select No, not at this time, then click Next.
6
