Note: If you like to monitor disk activity of the Serial ATA hard drives, you may at this time connect the hard disk LED of the system case to the Hard Disk LED Pins on the Serial ATA controller, see Figure 1, on page 2 for the location of the pins. For most systems connect the red wire to the pin located farthest from the mounting bracket.
6.Replace the computer cover and reconnect the power cord. Go to Driver Installation to install the Serial ATA
Driver Installation
This section provides information on how to install the Serial ATA
Windows2000
A new installation of Windows 2000 requires a floppy disk for the driver installation. To make this floppy disk, copy the contents of the NT4 folder, found on the driver CD, onto a blank floppy disk then follow the directions below.
For New Installation
1.Install the board and follow Microsoft procedures to install Windows 2000 accordingly.
2.At the Windows 2000 Setup screen, press F6 to install the driver.
3.Insert the floppy disk that you made above. Press S, then press Enter.
4.Select Silicon Image SiI... Controller for Windows NT4.0 and 2000, press Enter.
5.Press Enter again to continue and follow
4
