For Existing Installation
1.Install the board and boot up Windows.
2.At the Add New Hardware Wizard, insert the driver CD.
3.Select Specifythelocationofthedriver(Advanced), then click Next.
4.Check Specify a location, uncheck the other box, type
5.Click Next, then click Finish.
6.Remove the driver CD and restart Windows to complete the installation.
To Verify Windows 98SE / ME Installation
1.
2.Double click SCSI controllers and Silicon Image SiI 3114 ... Controller should be listed.
WindowsNT4.0
A new installation of Windows NT requires a floppy disk for the driver installation. To make this floppy disk, copy the contents of the NT4 folder, found on the driver CD, onto a blank floppy disk then follow the directions below.
For New Installation
1.Install the board and follow Microsoft procedures to install Windows accordingly.
2.At the Windows NT Setup screen, press F6 to specify and add the driver.
3.Press S, select Other, then press Enter.
4.Insert the floppy disk that you made above and press Enter.
12