Silicon Image SSD-DXXX(I)-4210 Device Power Supply. The device power, Absolute Maximum Ratings

ELECTRICAL SPECIFICATION		SSD-DXXX(I)-4210 DATA SHEET
	Table 8:	Signal Descriptions (Continued)
	Signal Name Pin(s)	Type Description

HDSTROBE

(UDMA write protocol active)

When UDMA mode DMA write is active in all modes, this signal is the data-out strobe generated by the host. Both the rising and falling edge of HSTROBE cause data to be latched by the device. The host may stop generating HSTROBE edges to pause an UDMA data-out burst.

KEY	20	-	Key. Reserved for the Connector Key.
STOP			While the UDMA mode protocol is active in
(UDMA			all modes, the assertion of this signal
protocol			causes the termination of the UDMA data
active)			burst.
-PDIAG	34	I/O	Pass Diagnostic. This open drain signal is
			asserted by the slave to indicate to the
			master that it has passed its diagnostics.
-RESET	1	I	Device Reset. An active low signal. When
			active, this signal sets all internal registers
			to their default state. This signal is held
			asserted until at least 25μs after power has
			been stabilized during the device power-on.
VCC	41, 42	-	Device Power Supply. The device power
			+3.3V/5V signal.

ABSOLUTE MAXIMUM RATINGS

Table 9: Absolute Maximum Ratings

Symbol	Parameter	Minimum	Maximum	Units
TS	Storage Temperature	-55	125	°C
TA	Operating Temperature	-40	85	°C
VCC	VCC with Respect to GND	-0.5	VCC + 0.5	V
VIN	Input Voltage	-0.3	VCC + 0.3	V
VOUT	Output Voltage	-	6.0	V

SILICONSYSTEMS PROPRIETARY

This document and the information contained within it is confidential and proprietary to SiliconSystems, Inc.

All unauthorized use and/or reproduction is prohibited.

4210D-03DSR PAGE 11 FEBRUARY 2, 2009