6.5 Setting the viewing position
Your portable DVD player is equipped with a pivoting swivelling TFT display screen.
In the event that you find the image quality of a DVD to be insufficient, slightly turn the device to op- timize the viewing angle.
The TFT display screen will turn 180° and fold down in this position thus allowing the display to operate when the device is closed up.
7. Use
•Carry out the required connections as described in chapter 5 and provide a power supply.
•Lift up the TFT display screen.
Switching the DVD player on and off
• Set the POWER switch to the "ON" position to switch the DVD player on.
The TFT display screen switches on and the back- ground image appears.
If no disc is inserted into the disc tray the notice "READING" will appear briefly followed by the prompt "NO DISC".
•To switch the DVD player off set the POWER switch to the position "OFF".
Buttons on the device and the remote control
Most of the functions described in this manual can be set using the buttons on the device or also the buttons on the remote control. When both buttons are possible for operation then both numbers will be specified after the button designation (for exam- ple DVD/USB/CARD button.
Display settings
•Press the FUNCTION button to access the display settings. The settings can be accessed at any time.
•Select with the navigation buttons one of the inputs Brightness (Bri), Contrast (Con) and Saturation (Sat).
•With the navigation buttons change the va- lue.
•To exit the settings press the FUNCTION button again.
•To reset the settings select the input Reset and press the button OK/ENTER.
8.Menu functions
Navigating in the menu
1.Press the SETUP button to access the setup menu.
The main menu appears GENERAL SETUP PAGE.
•With the navigation buttons and the button OK/ENTER you can carry out all settings in the menu.
* * GENERAL SETUP PAGE * *
TV DISPLAY | WIDE |
ANGLE MARK | OFF |
OSD LANGUAGE | ENG |
CLOSED CAPTIONS | OFF |
SCREEN SAVER | ON |
LAST MEMORY | OFF |
GOTO GENERAL SETUP PAGE
2.With the navigation buttons you select a menu by moving the yellow highlighting under the corresponding menu symbol.
3.With the navigation buttons you select an input in a menu by moving the yellow bar over an input.
4.With the navigation button you change an input in the sub menu and with the navigation button you move back to the previous menu level.
5.To confirm a selection press the button OK/ENTER.
• All navigation possibilities in a current menu are displayed at the lower edge of the menu.
• To exit the setup menu either press the button SETUP or select the last symbol "EXIT SETUP" and press the button OK/ENTER.
- 12 -
