Sim2 Multimedia HT500 LINK installation manual Switching On And Off, Switching On From Stand-By

5 SWITCHING ON AND OFF

The HT500LINK system consists of the Projector and the Di- giOptic™ Image Processor (which is also the system control centre). The DigiOptic™ Image Processor sends commands to the Projector and receives operating status information from the Projector and function commands from the user. The system can be controlled from either the remote control (via the infrared sen- sors on the DigiOptic™ Image Processor and on the Projector) or the keypad located on the rear of the Projector.

The two units have separate power supplies however: after connecting the unit to the electrical mains supply:

1)Set the two power switches to “I”; the DigiOptic™ Image Processor power switch is located on the external power supply unit (Fig. 13c), while the Projector switch is on the rear panel (Fig. 13a).

2)Turn on the DigiOptic™ Image Processor by pressing the button on the front panel (Fig. 13b).

Fig.13a

500 LINK

SS 1
LASERPR	ODUCT

Significant status signals are given in Table 3.

Table	3
		DigiOp tic ™ Im age	Pro jec tor
Status		Pro ce ss or
		Gree n LED B lue LED Gree n LED B lue LED

Off

Initialisation

S tand-by

On

C ooling

Optical link not active

C aution			-	-
Err or			-	-
: Off	: On	: Flas hing	- : Insi gnificant

If the No optical link or Error signals are active the system cannot be operated; if the Warning signal is active the system will operate but it may be unable to read certain input signals correctly.

SWITCHING ON FROM STAND-BY

Switching on the system (Fig.14):

I

O

Fig.13c

IMAG EPRO CESS OR

DIGIO
PTIC™	IMAGEPR
	OCESSOR
	ON
	OFF

ON

OFF

•from the remote control (keys 0-9)

•from the Projector keypad (keys · and ‚).

0

After a few seconds (system initialisation interval), the DigiOp- tic™ Image Processor and the Projector assume stand-by mode.

System status information is provided by two LEDs (green and blue) on the front panel of the DigiOptic™ Image Processor, a blue and green LEDs on the rear of the Projector.

RC	I
LIG
HT	2005

C
LA
SS	1
	L
		A
		SER	PRO	Fig.14
			DUCT

15