Sim2 Multimedia HT500 LINK Do not touch internal parts of the units, Replace the safety fuse

•Read this manual carefully and keep it in a safe place for future consultation.

This manual contains important information on how to install and use this equipment correctly. Before using the equipment, read the safety prescriptions and instructions carefully. Keep the manual for future consultation.

•Do not touch internal parts of the units.

The units contain electrical parts carrying high voltages and operating at high temperatures. Do not remove the cover from the units, refer to qualified service personnel for all repair and maintenance requirements.

The warranty will be automatically invalidated if the cover is removed from the units.

•Power supply disconnect device.

The device for disconnecting the units from the mains power supply is constituted by the power cable plug. En- sure that the power cable plugs and the electrical mains socket outlets are easily accessible during installation operations. To disconnect the units from the electric power supply, pull the plug to remove it from the socket outlet. Do not pull the power cable.

•Use only the specified type of mains power sup- ply.

Connect the units to a mains electrical supply with rated voltage of between 120-240 VAC, 50/60 Hz and equipped with a protective earth connection. If you are unsure of the type of mains power supply in your home, consult a qualified electrician. Ensure that the power draw of the units is commensurate with the rating of the electrical soc- ket outlets and any extension cables that are used.

For the DigiOptic™ Image Processor use exclusively the power supply unit provided or an alternative power supply unit expressly approved by SIM2.

Fig.1

Fig.2

•Replace the safety fuse

250 V	4
T 5A H
2

1 3

Fig.3

•Beware of power supply cables.

Position the power supply cables so that they do not con- stitute an obstruction. Position the power supply cables where they cannot be reached by children. Install the units as close as possible to the wall electrical socket outlet. Do not tread on the power cables, make sure that they are not tangled or pulled; do not expose the power cables to heat sources; make sure that the power cables do not become knotted or kinked. If the power cables become damaged, stop using the system and request the assistance of an authorised technician.

•Disconnect the apparatus from the mains power supply in the event of electrical storms and when not in use.

To avoid damage that could be caused by lightning striking in the vicinity of your home, disconnect the units in the event

5