of electrical storms or when the system will remain unused for prolonged periods.
•Avoid contact with liquids and exposure to hu- midity.
Do not use the units near water (sinks, tanks, etc.); do not place objects containing liquids on top of or near the units and do not expose them to rain, humidity, dripping water or spray; do not use water or liquid detergents to clean the units.
•Prevent the units from overheating.
In order to allow the Projector cooling, keep at least 40 cm ( 16”) of space between the rear of the projector and the nearest wall or obstruction. Do not place the devices near heat sources such as heaters, radiators or other devices that generate heat (including amplifiers).
Do not obstruct ventilation openings.
Do not place the units in confined, poorly ventilated posi- tions (bookcases, shelves, etc.).
•Do not expose the eyes to the intense light emitted by the lamp.
Never look directly at the lamp through the ventilation opening when the unit is switched on.
Risk of eyesight impairment. Ensure also that children do not look directly at the lamp.
•Beware of the lens movements
Avoid positioning objects close the lens. The movements ( horizontal and vetical) could be obstructed by objects, or damage may arise from the fall of the objects.
•Position the unit on a stable surface.
To avoid serious injury to persons and damage to property, make sure the units are placed on a level, flat and stable surface from which they cannot fall, tip over or slide. Pay special attention if the units are placed on a trolley so that they can be moved around. Ensure that the units are not subjected to impact.
•Do not insert objects through the units’ openin- gs.
Make sure that no objects are inserted inside the units. If this should occur, disconnect the unit from the power supply immediately and call an authorised technician.
•Energy Saving
When the system is left idle for a long period disconnect the Projector and the DigiOptic™ Image Processor from the main power supply.
This precaution allows to save energy and to prevent wear and tear of the electronics devices.
6
