MEMORIES
The main parameters of the image may be saved in distinct groups of values (known as ‘Memories’); these parameters can subsequently be applied all together by way of a single command.
There are 3 distinct Memories (Memory 1, Memory 2, Memory
3) for each of the 25 signal types managed:
1 | VIDE O |
2 | VIDE O |
3 | S |
4 | S |
5 | COMP/RGB(YCrCb 15KHz) | 5 | COMP/RGB(RGB 15KHz) | ||
5 | COMP/RGB(YCrCb | 32KHz) | 5 | COMP/RGB(RGB | 32KHz) |
6 | COMP/RGB(YCrCb 15KHz) | 6 | COMP/RGB(RGB | 15KHz) | |
6 | COMP/RGB(YCrCb) |
| 6 | COMP/RGB(RGB) |
|
7 | COMP/RGB(YCrCb 15KHz) | 7 | COMP/RGB(RGB 15KHz) | ||
7 | COMP/RGB(YCrCb) |
| 7 | COMP/RGB(RGB) |
|
8 | COMP/RGB(YCrCb 15KHz) | 8 | COMP/RGB(RGB | 15KHz) | |
8 | COMP/RGB(YCrCb) |
| 8 COMP/RGB(RGB) |
|
9 GR APH IC S RGB
10 GR APH IC S RGB
11 DV
11 DV
12 H DMI
making a total of 75 different available Memories.
The image parameters that can be saved/recalled by the Mem- ories management system are the following:
Image | Picture |
BRIGHTNESS | ASPECT |
CONTRAST | COLOR TEMP. GAIN (R/G/B) |
COLOR | COLOR TEMP. GAIN OFFSET (R/G/B) |
TINT | COLOR TEMP. |
SHARPNESS | OVERSCAN |
FILTER | GAMMA |
SHARPNESS MODE | Setup |
VIDEO TYPE | |
NOISE REDUCTION | LAMP POWER |
Some of these parameters may not be available for certain inputs or certain input signals, as indicated in Tables 4 and 5. The menu page for the Memories management functions is
activated by pressing the key on the remote control or the
flkey on the keypad (Fig.28).
| 500 | LINK |
RC |
| |
LIG | I |
|
HT | 2005 |
|
�� |
|
|
� �� |
|
|
| 1 |
|
| 2 |
|
| 3 |
|
| - |
|
CLASS |
|
1 |
|
LASER | PRODUCT |
|
Fig.28 The operations that can be performed on each memory se- lected are described here below.
Save a memory
To save the current values of the image parameters in Memory 1, use the · and ‚ keys to move to line ‘1’ and then open the
Memories
0 | Auto |
|
|
|
1 | S |
| S ave current se ttings |
|
2 | I |
| S ave initial se ttings |
|
3 | S |
| R ena me |
|
Fig.29
Recall a memory
To recall a Memory, select the desired line and press ‡. The parameters saved in the selected Memory will be applied to the image displayed and a message will appear to confirm the operation Memory 1 recalled. The Memory recalled will be
26