Sim2 Multimedia HTL40 Recall Memories, Restore Memories, Rename Memories, Restore Current Values

�������

RECALL MEMORIES

To retrieve memories select the required line and press the ▶ key. The parameters stored in the selected memory will be applied to the displayed image, while a confirmation message will be displayed to confirm the operation ‘MEMORY 1 RECALLED.’. The retrieved memory is associated with the specific source and signal type and called automatically whenever that specific combination of source and signal type is selected.

RESTORE MEMORIES

To restore the original values of a previously modified Memory, select the line relative to the Memory in question and open the corresponding drop-down menu ◀ key). Select the line ‘SAVE INITIAL SETTINGS’. To confirm the operation, the message ‘INITIAL SETTINGS SAVED IN MEMORY 1’ is shown at the bottom of the display and the letter “I” appears to the left of the memory name.

RENAME MEMORIES

All Memories can be named. To enter a name (maximum length of 12 alphanumeric characters) select the option ‘Rename’ in the relative drop-down menu. The text is input in accordance with the method described in the heading “TEXT INSERT”.

RESTORE CURRENT VALUES

When you open the “MEMORIES” menu a copy of the current settings is saved in a temporary memory (designated by 0 - AUTO). After having retrieved one or more memories you can restore the set- tings existing at the time you opened Memories menu by selecting Memory ‘0’ (0 - AUTO). Note that this operation must be executed before the Memories’ menu page disappears (30 seconds after the final operation with the remote control or keypad). The next time it appears, in fact, the temporary memory will contain new informa- tion that takes account of any Memories that were selected in the penultimate access to the ‘MEMORIES’ page.

Memory 0 can be used even when you do not wish to enable Memories management for the signal in use. In effect, once it is selected, when a source is chosen the system will automatically reload the settings that were active the last time the memory was retrieved.

INFO

Displays information concerning the displayed video/graphic signal and the operating status of the system.

This function is displayed on pressing the key on the remote control (or, in the absence of the On Screen Display, the ▶ key on the keypad).

QUICK MENUS

The quick menus provide access to the main adjustments that affect image quality without calling the main menu. Brightness,CONTRAST, COLOUR, TINT, SHARPNESS and FILTER adjustments appear at the bottom of the screen one after the other when the

▲and ▼keys are pressed.

MESSAGES

The following messages may appear during operation of the sys- tem:

No Signal

The system does not recognise any signal applied to the selected input. In this case:

•Make sure the selected input is connected to a video or graphic signal and that that source is functioning correctly.

•Check the condition of the cables used to connect the system to the various sources.

•Make sure the video or graphic signals supplied by the source are compatible with the system’s technical specifications and, in particular, with those of the selected input.

Out of range

This message appears when either the resolution or the vertical/ horizontal frequency of the input signal exceeds system specifica- tions (e.g. a QXGA graphic signal) or when an input is supplied with an incompatible signal (e.g. after setting the components input to YCrCb 15kHz a progressive signal is connected).

28