![](/images/new-backgrounds/1279806/27980613x1.webp)
�������
• Read this manual carefully and keep it in a safe place for future consultation.
This manual contains important information on how to install | � |
| � |
and use this equipment correctly. Before using the equipment, |
|
read the safety prescriptions and instructions carefully. Keep the |
|
manual for future consultation. |
|
•Do not touch internal parts of the units.
The units contain electrical parts carrying high voltages and operating at high temperatures. Do not remove the cover from
the units, refer to qualified service personnel for all repair and |
|
| Fig.2 |
maintenance requirements. The warranty will be automatically |
|
| |
|
|
| |
invalidated if the cover is removed from the units. | • | Changing the fuses. |
|
|
| ||
• Power supply disconnect device. |
| Before changing the fuse disconnect the unit from the | |
| mains power supply. |
| |
The device for disconnecting the units from the mains power |
|
| |
supply is constituted by the power cable plug. Ensure that the |
| The fuse compartment is next to the mains power connector | |
power cable plugs and the electrical mains socket outlets are |
| (Fig. 3). Remove fuse carrier (2) with the aid of a flat blade | |
easily accessible during installation operations. To disconnect the |
| screwdriver, then change fuse (3). Insert a new spare fuse (4). | |
units from the electric power supply, pull the plug to remove it |
| Use only T 3.15A H fuses. |
|
from the socket outlet. Do not pull the power cable. |
|
|
|
• Connect the unit only to the type of power supply indi- |
| � |
|
cated. |
| ����� |
|
Connect the units to a mains electrical supply with rated voltage of |
| ��������� |
|
between |
|
|
|
earth connection. If you are unsure of the type of mains power |
| � |
|
supply in your home, consult a qualified electrician. Ensure that |
| � | |
the power draw of the units is commensurate with the rating of |
|
| |
the electrical socket outlets and any extension cables that are |
|
| � |
used. For the DigiOptic™ Image Processor use exclusively the |
|
| |
power supply unit provided or an alternative power supply unit |
|
|
|
expressly approved by SIM2. |
|
|
|
• Connection of the units to the mains power supply. |
| |
Make the connection as shown in Fig.1. Before connecting the |
| |
panel to the electrical mains supply, follow the setup instructions | Fig.3 | |
carefully. | ||
| ||
| • Be careful with cables. | |
| Position the power supply cables so that they do not constitute | |
| an obstruction. | |
| Keep cables out of the reach of small children. | |
| Install the units as close as possible to the wall electrical socket | |
| outlet. Do not tread on the power cables, make sure that they | |
| are not tangled or pulled; do not expose the power cables to | |
| heat sources; make sure that the power cables do not become | |
| knotted or kinked. If the power cables become damaged, stop | |
| using the system and request the assistance of an authorised | |
| technician. |
Fig.1 7