5.Each horizontal and vertical Velcro strips in the frame will share into the same grommet in the four corners of the screen. (Fig. 17)
6.Figure 18 shows the strips in the laced position. You can see how evenly distributed the screen is against the frame.
7.At this point the frame is still 80% inflated.
8.Inflate the frame up completely to 100%.
9.Check to see where the screen needs to be tightened. The screen will need adjusted to areas where less taut.
10.Deflate back to 80% to adjust screen.
11.Now remember the areas that need to be tightened and adjust the Velcro strips as needed.
12.Upon completely attaching the screen,
Fig. 17
Fig. 18
Page 10
