Troubleshooting Guide
Problem | Solution | |
Wrinkles & Creases in the screen | 1. | Remove the screen prior to deflating and roll it back onto the |
Note: Some wrinkles are normal and will not | tube for storage. | |
|
| |
affect the viewing image. | 2. | Setup the screen and frame in a warm environment (Sunlight) |
| to remove the wrinkles from the screen. | |
The frame is deflating over time | 1. | Be sure to remove the air pump hose after inflating. Air can |
| leak back through the pump if not removed. | |
| 2. | Check the inner rubber air valves are seated properly prior to |
Note: If the frame is left inflated overnight | closing outer threaded cap. | |
|
| |
during a moderate temperature change the | 3. | Listen for air holes in the frame around the seams. You may |
frame will show a loss of air pressure. Be sure | use mild soap and water to locate the leak. | |
to deflate frame and store after usage. | 4.Be sure to remove all soap residues prior to using a patch kit. | |
| ||
No power to the speakers | 1. | Check that the AC power cables are plugged into a working |
| outlet. | |
| 2. | Check the AC power cable connection on the back of the |
| speakers. Be sure it is inserted completely. | |
| 3.The off/on switch should illuminate when on if power is | |
| connected correctly. If power is still not present check to see if | |
| the fuse needs replaced. When removing the fuse block you will | |
| find a spare fuse. | |
No audio sound from the speakers | 1. | Check that all the audio cables are connected correctly. |
| 2. | Be sure the volume levels on the speaker, volume control box |
| and DVD player are set correctly | |
Distorted Sound from speakers. | 1. | If you are playing at a loud volume level, reduce the volume |
|
|
|
Audio humming noise in the speaker | 1. | Keep audio cables away from the AC wires. |
| 2. | Keep all your components plugged into the same GFI outlet. |
| This will eliminate ground looping. | |
| 3. | Reduce the level control on the speaker. |
|
|
|
Video is not bright enough on the screen | 1. | Use a projector with enough lumens to better view your video |
| for certain outdoor conditions. | |
| 2. | Use the supplied black light guard to cut down on rays of |
| unwanted light. | |
Part of the picture is missing viewing in the rear | 1. | Place the projector on a stand so its height is centered in the |
projection position. | screen. | |
|
|
|
Page 21