Unpacking the Screen
1.Remove all the items from box as shown at right. Don’t cut the boxes too deep, as this may damage the screen. (Fig. 2)
Note: Keep this box in good condition, as it may be used to store the screen when not in use.
Inflating the Screen
1.Remove the frame from the package. Unroll the screen as shown at right. Be sure both bases are facing the correct way. (Both air valves should be facing the same direction.) (Fig. 3)
2.Plug the AC air pump into an AC power outlet. Note: Power supply must be 120V AC, 60 Hz. Use a properly grounded GFI outlet if using the product outdoors.
3.Locate the air inlet/outlet valves. You will notice that each valve on each base has two layers of seals that cutoff the airflow. The outer seal is a threaded cap that screws into place. (Fig. 4)
4.The inner seal is a rubber check valve designed to hold in air when a certain amount of pressure presses against it. (Fig. 5)
Fig. 2
Fig. 3
Fig. 4 | Fig. 5 |
Page 6
