5.As the frame fills with air, be sure it is clear of any nearby objects. Guide the frame up as it fills with air, helping to unfold and expand it. It should take approximately 5 minutes for the screen to inflate. (Fig. 9 - 12)
6.When the screen is about 80% full (frame is standing up but there is a slight dip in the top part of the frame), remove the hose from the inlet/outlet valve while the pump is still in the “on” position. (Fig. 13) (If in the “off” position you will lose air through the pump) After attaching the screen to the frame in the following steps, you will “top it off” by
You are now ready to attach the screen using either the screen lace or Velcro strips. Please see instructions for attaching the screen to the frame further on in the instruction manual.
Tip: If connecting the screen to the frame is difficult, release some air to allow for more slack in the frame.
7.After the screen has been attached to the frame, continue to inflate the frame so that the screen is pulled taut. (Fig.
14)Check the valve on the other base. Remove the cap and check to make sure the inner seal is seated correctly. In final be sure both valves are sealed correctly.
Note:
•The dark colored material from which the Inflatable Theater Frame is construction tends absorb the heat from the sun, which causes the air inside the frame to warm up and expand if the screen is used on a sunny day. If the frame is left out overnight, the air inside the frame will cool and contract, which may cause the frame to sag slightly. The sagging is not due to the frame losing air, and can be corrected by "topping off" the frame with air prior to use.
•It is recommended to keep the supplied air pump on hand to add additional air when using the XL Theater System during an all day event.
•Be sure to deflate frame and store after usage.
Page 8
Fig. 9
Fig. 10
Fig. 11
Fig. 12
Fig. 13
Fig. 14
