Simplicity 1694924 manual Install Idler Assembly and Belt Guide, Discard Taptite Screws

Assembly

A

Figure 7. Discard Taptite Screws

A. Taptite Screws

Install Idler Assembly and Belt Guide

1.Remove and discard the two taptite screws (A, Figure 7) from the locations shown.

2.Check that the idler assembly stack-up is correct for your application See Figure 8. If not follow the descriptions to make the corrections.

3.Install 5/16-18 x 7/8 capscrews (C, Figure 9) through the mower deck and arbor as shown. Tighten capscrews.

4.Install the idler assembly (A) to the mower deck using 5/16-18 x 7/8 capscrews (C) and 5/16-18 nuts. The belt guide should be positioned as shown.

5.44” and 50” Mowers - Remove and discard the taptite screw in existing hole (F, Figure 10) if unit has roller bars.

6.44” and 50” Mowers - Install wire belt guide (A, Figure 10), spacer (E) washers (D), washer (C) and capscrew (B) as shown.

38” Mowers	44” and 50”
	Mowers
	A
	B
H	C
	B
	G
F
	D
B	E

Figure 8. Idler Assembly Stack-Up

A.Capscrew, 3/8-16 x 2

B.Washer(s), 3/8

C.Pulley, Idler, 2-3/4

D.Idler Bracket

E.Nut, Whiz Lock, 3/8-16

F.Belt Guide, Wire, 38” Mowers

G.Belt Guide, Flat, 44” and 50” Mowers

H.Spacer

B	D
A
	C

Figure 9. Install Idler Assembly

A.Idler Assembly

B.Belt Guide

C.Capscrew, 5/16-18 x 7/8

D.Nut, Whizlock, 5/16-18

10www.SimplicityMfg.com www.MasseyLawn.com www.AGCOLawn.com www.Snapper.com